While removing orange peel and deep defects you are also polishing the paint rather than leaving sanding marks which reduces the steps needed afterwards.
New to Version 2:
- Multiple diameter pads available.
- Foam interlayer changed from 3/8" to 3/16".
- Redesigned foam interlayer for more effective orange peel removal.
- Redesigned without holes for longer durability.
Features:
- Reduce orange peel and deep defects while simultaneously polishing paint.
- Equivalent to 2000 grit sandpaper with out the dulling of paint and sanding haze.
- Reduce orange peel without sanding.
- Orange peel removal without the haze generated by sanding.
- Polish the paint while removing the ridges of orange peel.
- Less dust and clean up prior to finishing polish.
Directions:
- Attach to hook & loop backing plate with rotary polisher for best results.
- Work a 2' x 2' section or larger to keep heat down as needed but remember the larger the area the more time it will take to level orange peel and defects.
- Begin working polish on low speed for a pass.
- Step up speed to approximately 1100 rpm (adjust as needed).
- With proper lighting observe the level of orange peel removal while you work noting precise surface contact without pressure to level ridges.
- After completing each section wipe off paint with soft microfiber towel.
- Brush pad in direction of fibers to remove residue.
- Apply a couple more drops of polish for next section.
- Switch out pads as needed when cut has been compromised and set aside to clean by hand.
Pad Care:
- Spray cleaning solution on face of pad.
- Brush with Pad Cleaning Brush.
- Rinse face of pad.
- Allow to dry before next use.
Precautions:
- Note that these pads are the equivalent of 2000 grit sandpaper.
- Please only use these pads if you are sure the orange peel is in the upper (clear coat) and not the color coat layer.
- Be careful near edges and body lines or avoid completely if you are not entirely secure in your knowledge of heavy defect removal.
- Do not use without sufficient skill level knowledge of clear coat thickness in conjunction with a paint thickness gauge.
- PLEASE NOTE: THESE PADS ARE DECEPTIVE IN THEIR AGGRESIVENESS. Use NO PRESSURE and observe the paint temperature often.
- DO NOT USE WITHOUT PAINT GAUGE UNLESS YOU HAVE TAKEN RESPONSIBILITY FOR MOVING FORWARD WITHOUT ONE.
Specifications:
- Size: 3" diameter.
- Thickness: 5/16".
- Pore size: 80ppi.
- Foam hardness: 3kpa.
- Material: Denim polishing surface with hook and loop backing.
- Color: Denim.
