CARPRO HydrO2 Foam, or HydroFoam, is for anyone who is short on time but still wants their car to have an impressive finish. This 2-in-1 car foam shampoo will have a vehicle shining in minutes. Spray pH-neutral HydroFoam on with a foam cannon or apply it by hand to gently lift dirt and debris off your paint. When you rinse it off, the glass fibers and fluoropolymers of Hydro2 kick in, creating a water-repellent finish with a glossy shine. This protective coating lasts up to three months depending on driving conditions.

The CARPRO Shine in One Step

A single-stage car foaming wash lets you enjoy the beauty of a wash and wax while just doing the wash. It’s safe for paint, clear coat, glass, plastic, brake calipers and most other exterior surfaces. By diluting it at a 1:9 ratio and using a Merino wool wash mitt, you get impressive cleaning power with almost no risk of swirls. The hydrophobic coating it leaves behind also resists UV rays, dirt, solvents and most acids. You don’t have to wait around, either — as soon as you’ve rinsed off the HydrO2 and given a towel wipe-down, your car is ready to drive.

If you need a good-looking vehicle fast, CARPRO delivers. HydrO2 car wash foam is perfect for daily drivers, hectic schedules and those learning the ropes of car care. See how well it works by checking out the customer images and reviews below. An Autogeek expert can answer any questions you have by phone or email. We also ship fast.

Directions:

1. First, you never want to apply CARPRO HydrO2 Foam in direct sunlight or on a hot surface. This will cause streaking that does NOT come off easily.
2. Once you’re in a sufficiently shaded area, rinse the vehicle thoroughly. You should leave the surface wet and clean of any soap residue.
3. If you are using a foaming device, coat the whole car with the CARPRO HydrO2 Foam mixture before moving onto the wash mitt step. If you are hand washing out of a bucket, wash the car section by section using your wash mitt. Immediately rinse each section well before moving onto the next panel.
4. If you’ve used your foaming device, now go over the whole car with your wash mitt. It’s recommended you use a Wool mitt for best results.
5. Be sure to rinse thoroughly immediately after washing.
6. Once the car is fully rinsed, remove any remaining water by either blowing with a dryer or with a waffle weave drying towel.