PRECAUTIONS

• Apply in temperatures between 10-30°C, 50-90°F.
• Apply in a closed, well ventilated indoor area with air humidity not exceeding 70%.
• Wear protective gloves.
• Use fresh applicators & microfiber towels for application of additional layers (do not use previously used towels).

WHAT YOU’LL NEED

• 3 Microfiber Towels
• 2 Applicators
• Protective Gloves
• Diamond Body Prep

APPLICATION TIPS

• If applying in high heat or high humidity, lower time between application and removal. Test over a small area to determine appropriate time to let the coating bond to the surface.
• Apply PRO 60 to body, headlights, rubber, and metal trim.
• Apply PRO HYDRO to body, headlights, and metal trim, but not to rubber/plastic.
• PRO 60/PRO HYDRO: As the coating bonds to the surface a haze will appear. This indicates the coating is ready to remove. If product dries on the surface or is difficult to remove, re-wet the area with more product and immediately buff off.

IR CURING LAMP INSTRUCTIONS:

• Temperature: 50-60°C / 120-140°F
• Distance to bodywork: 60-70 cm / 24-28 inches.
• Time: 15-20 minutes for each section.

INSTRUCTIONS

• Wash, polish and treat areas to be coated with Diamond Body Prep.
• Shake PRO 60 well for 15 seconds. Place 15 drops on an applicator and apply to 1-2 sections of the car in a crosshatch fashion. Wait 1-3 mins watching for a haze to appear, then gently buff the treated areas and buff off excess with a low-nap microfiber towel.
• Wait one hour and then apply a second coat repeating the process.
• Wait one hour and apply a coat of PRO HYDRO that will give the coating system its amazing hydrophobicity. If curing with IR lamps, do so prior to applying PRO HYDRO.
• Shake PRO HYDRO well for 15 seconds and then apply 15 drops on an applicator. Apply on 3-4 sections of the car in a crosshatch fashion.
• Wait up to 7-10 mins and buff off excess with a low-nap microfiber towel.
• Wait one hour and apply a second coat repeating the process (recommended, not required).
• Allow coating system to cure for 2 hours before using the vehicle.